Precut Invisible Bug Guard Installation
1. Clean the surface area thoroughly. Remove all dust, dirt, and debris with any non-acidic cleaner
2. Remove backing liner from the protective film while spraying the adhesive side with the spray, align and rest the film onto the surface. The solution will allow you to adjust it around for perfect placement. Spray the outside of the film. This helps the squeegee easily slide along the film during installation.
3. Use your application card to “squeegee” the spray solution out from under the film. Start from the center of the film, working your way to the outside edge. Use firm, but smooth and even strokes to remove any trapped water. If you do have some trapped moisture, you may be able to pull the film up for reapplication. Be careful though, weakened, damaged, or ill-prepared, re-sprayed painted surfaces could flake off. If this could be the case, pierce the bubble with a sewing needle and press the moisture out towards the hole. The small puncture will heal back up over time.
4. When you are finished, use the microfiber or lint-free towel to clean the area. Let the protective film dry and cure for at least 24 hours prior to driving. Maintain by regularly washing with soap & water. Wax occasionally.
Maintenance Care
If you experience trouble with the installation, contact us for assistance.
ALL WARRANTY CLAIMS MUST BE ACCOMPANIED BY PICTURES TO: help@lamin-x.com